News: Common Damage Causes And Treatment Methods Of Black PU Timing Belts

The damage of the black PU timing belt is not only related to the quality, but also has a lot to do with the method of use, equipment, environment, etc. Therefore, when buying a timing belt, you should not only buy a high-quality timing belt, but also pay attention to the synchronization during use. Bring damage to the factors and take precautions. The following Yonghang transmission belt manufacturer introduces the common damage causes and treatment methods of black pu timing belts:

The black pu timing belt is broken:

    1. Overload-change the design, increase the size of the timing belt
    2. Overload caused by mechanical failure-to prevent recurrence
    3. Too much impact will cause overload-change the design or eliminate the impact
    4. The diameter of the synchronous pulley is too small-change the design and adopt a large diameter pulley
    5. Belt bending-pay attention to daily use
    6. Run the belt to the flange-adjust the centering, recheck the flange shape
    7. Embedding foreign objects ------ improve the environment or set up a protective cover
    8. Slightly reduced due to core corrosion (steel)-improve the environment or replace the aramid fiber rope, stainless steel core
    9. The strength of the raw material of the timing belt is not enough, and it is easy to rupture with slight trauma-choose a material with good toughness.
    10. Speed ​​and shifting speed, vigorously and quickly replace the timing belt
    11. The timing belt is too long or too short/the load is too large-the inspection and shutdown included in the regular inspection project

The black pu timing belt is easy to fall off:

    1. The timing belt is too long and the two timing belts are staggered-choose the timing belt of the same specification/brand

    2. Insufficient tension of the tension wheel-make adjustments and replace if necessary

    3. The timing belt guide wheel does not form a horizontal synchronous downward force-adjust the levelness of the PU timing belt and the pulley

    4. Long-term work causes the belt to become longer-cut it short and reconnect it